In studying on your CCNA Examination and getting ready to earn this important certification, you might be tempted to spend tiny time finding out static routing and head appropriate for the more enjoyable dynamic routing protocols like RIP, EIGRP, and OSPF. That is an easy to understand blunder, but nonetheless a mistake. Static routing isn't intricate, but it really’s a vital topic around the CCNA Test in addition to a valuable skill for genuine-entire https://en.search.wordpress.com/?src=organic&q=토토사이트 world networking.
To create static routes on a Cisco router, you utilize the ip route command followed by the desired destination network, community mask, and either another-hop IP handle or perhaps the regional exit interface. It’s crucial to help keep that final part in your mind – you’re either configuring the IP address with the downstream router, or the interface within the local router that should function the exit interface.
Permit’s say your local router features a serial0 interface by having an IP address of two hundred.1.one.one/30, along with the downstream router that will be the up coming hop will get packets on its serial1 interface by having an IP tackle of two hundred.1.1.2/30. The static route are going to be for packets destined with the 172.ten.one.0 network. Possibly of the subsequent ip route statements can be appropriate.
R1(config)#ip route 172.ten.1.0 255.255.255.0 two hundred.one.1.two (following-hop IP tackle)
OR
R1(config)#ip route 172.ten.one.0 255.255.255.0 serial0 ( nearby exit interface)
It's also possible to produce a static route that matches just one desired destination. This is the host route, and has 255.255.255.255 for the mask. If the above mentioned static routes should only be accustomed to deliver packets to 172.ten.one.1., 사설사이트 the next commands would do the job.
R1(config)#ip route 172.10.1.1 255.255.255.255 200.1.1.two (up coming-hop IP deal with)
R1(config)#ip route 172.ten.1.one 255.255.255.255 serial0 ( local exit interface)
Finally, a default static route serves like a gateway of final vacation resort. If there isn't any matches to get a desired destination in the routing desk, the default route might be utilized. Default routes use all zeroes for the two the vacation spot and mask, and all over again a following-hop IP deal with or local exit interface can be used.
R1(config)#ip route 0.0.0.0 0.0.0.0 two hundred.one.1.2 (upcoming-hop IP handle)
R1(config)#ip route 0.0.0.0 0.0.0.0 serial0 ( local exit interface)
IP route statements appear straightforward adequate, but the small print regarding the up coming-hop IP deal with, the area exit interface, default static routes, as well as syntax in the command are critical for success on CCNA exam working day and in the true globe.