In researching on your CCNA Test and making ready to make this precious certification, you might be tempted to http://query.nytimes.com/search/sitesearch/?action=click&contentCollection®ion=TopBar&WT.nav=searchWidget&module=SearchSubmit&pgtype=Homepage#/토토사이트 invest tiny time learning static routing and head proper for the more exciting dynamic routing protocols like RIP, EIGRP, and OSPF. This is often an easy to understand mistake, but nonetheless a mistake. Static routing isn't complicated, but it’s a crucial subject matter to the CCNA Test and a important ability for actual-globe networking.
To develop static routes over a Cisco router, you employ the ip route command accompanied by the spot network, network mask, and either the following-hop IP deal with or perhaps the local exit interface. It’s essential to help keep that last aspect in mind – you’re either configuring the IP address from the downstream router, or maybe the interface on the nearby router that may serve as the exit interface.
Allow’s say your 메이저사이트 neighborhood router has a serial0 interface with the IP address of two hundred.one.1.1/thirty, plus the downstream router that would be the subsequent hop will obtain packets on its serial1 interface with the IP address of two hundred.one.one.two/30. The static route will be for packets destined to the 172.ten.one.0 community. Possibly of the next ip route statements could be right.
R1(config)#ip route 172.ten.1.0 255.255.255.0 200.one.1.two (future-hop IP handle)
OR
R1(config)#ip route 172.10.one.0 255.255.255.0 serial0 ( area exit interface)
You may as well write a static route that matches just one location. This is a host route, and has 255.255.255.255 for the mask. If the above mentioned static routes ought to only be used to deliver packets to 172.ten.one.1., the following commands would do The task.
R1(config)#ip route 172.10.1.one 255.255.255.255 200.one.one.two (following-hop IP tackle)
R1(config)#ip route 172.10.1.one 255.255.255.255 serial0 ( local exit interface)
Eventually, a default static route serves being a gateway of last vacation resort. If there are no matches for a place within the routing desk, the default route are going to be employed. Default routes use all zeroes for equally the destination and mask, and all over again a upcoming-hop IP handle or local exit interface can be employed.
R1(config)#ip route 0.0.0.0 0.0.0.0 two hundred.one.1.two (future-hop IP address)
R1(config)#ip route 0.0.0.0 0.0.0.0 serial0 ( regional exit interface)
IP route statements feel simple sufficient, but the main points regarding the following-hop IP address, the nearby exit interface, default static routes, and the syntax on the command are crucial for achievement on CCNA exam working day and in the true globe.